Date: Wed, 13 Sep 89 17:02:09 BST From: J.Heaton%manchester-computing-centre.ac.uk@NSFnet-Relay.AC.UK Subject: FT212 mods From: SV0DR@PI8EAE To: YAESU@EU FT 212RH extended freq. coverage mod. Remove the bottom and top covers and remove the front panel cover. You must then remove the front board by carefully unpluging it (try not to touch the lcd display). On the back of this board which is the control unit locate jumpers 1 through 12 and unsolder any that are soldered. All jumpers must be open (1-12 only). Reinstall the control unit and just turn on the radio for a few seconds. now turn it off again and remove the control unit again and solder jumpers 3, 4, 5, 11 only. Put everything back together and apply power. The display will read 000. Push the MHz button and rotate the main dial until 132.000 reads on the display, then press D/MR once. Now press again the MHz button and rotate to 180.000 and press the D/MR again. the radio is now programmed to operate from 132 to 180 mhz. mine has tx and rx through the entire spectrum with excellent sensitivity from 136 to 178. Dont forget that transmitting outside the amateur band is not allowed so please consult your local athorities for a special permit. 73s and have fun.......de SV0DR @ SV1IW John Heaton Copied from the QRZ! Windows Ham Radio CDROM